technical support

Further assistance may be obtained by contacting Duggan Profiles on +353-56-7722485
ProSigma+ BOLT-ON CLEAT
Standard Bolt-on cleats are available to suit our range of Sigma+ and Cee sections. Product codes and drawings are available in the table below.

In addition to the general information already provided on the Introduction page some additional data specific to these cleats is outlined in the diagram below. For information on stiffened or extended versions of these please select the appropriate option from the menu on the left.  
Primer:

These cleats are supplied with an alkyd based primer with zinc phosphate as active corrosion preventing pigments. A technical data sheet on the primer used is available here. Note: If unprimed Bolt-on cleats are required these should be specified using the product codes outlined on the Unprimed Cleats page on this site.  
Load Data:

Structural data for these cleats is included here.
 
ProSigma+ Bolt-on Cleat product codes and drawings:
  Code: Description: DXF File PDF File
Bolt-On Cleat DP-CLB145 145 Bolt-on Cleat: AutoCad File PDF File
DP-CLB175 175 Bolt-on Cleat: AutoCad File PDF File
DP-CLB205 205 Bolt-on Cleat: AutoCad File PDF File
DP-CLB235 235 Bolt-on Cleat: AutoCad File PDF File
DP-CLB265 265 Bolt-on Cleat: AutoCad File PDF File
DP-CLB300 300 Bolt-on Cleat: AutoCad File PDF File
DP-CLB325 325 Bolt-on Cleat: AutoCad File PDF File
Click on the DXF or PDF icons above to download the CAD (.dxf) or .pdf file.

Trouble downloading?
Right-Click on the DXF icon: this will bring up a menu where you can click on either
'Save Target As' or 'Save Link As'.
Then, after saving the DXF file to your computer you can run your CAD software
and open the DXF file that you saved.